Blade and Shaft Crack Detection Using Torsional Vibration Measurements Part 2: Resampling to Improve Effective Dynamic Range

Abstract

The primary goal of the development project was to demonstrate the feasibility of detecting changes in blade bending natural frequencies (such as those associated with a blade crack) on a turbine using non-contact, non-intrusive measurement methods. The approach was to set up a small experimental apparatus, develop a torsional vibration detection system, and maximize the dynamic range and the signal to noise ratio. The results of the testing and analysis clearly demonstrated the feasibility of using torsional vibration to detect the change in natural frequency of a blade due to a change in stiffness such as those associated with a blade crack. However, it was found that harmonics of shaft operating speed, created as an unwanted artifact of the measurement method, resulted in spectral regions in which the effective dynamic range was inadequate to detect low-level torsional vibration associated with the natural frequencies. The loss of effective dynamic range was due to the “skirts” created by the sampling window. Application of order resampling, followed by frequency resampling, to the torsional vibration waveform increased the effective dynamic range and improved the ability to identify shaft torsional and blade bending natural frequencies.

References

Vance

John M.

, Rotordynamics of Turbomachinery, John Wiley & Sons, New York, 1988, pp. 377ff.

Maynard

K. P.

Trethewey

, “On The Feasibility of Blade Crack Detection Through Torsional Vibration Measurements,” Proceedings of the 53rd Meeting of the Society for Machinery Failure Prevention Technology, Virginia Beach, Virginia, April 19–22, 1999, pp. 451–459.

McDonald

Gribler

, “Digital Resampling: A Viable Alternative for Order Domain Measurements of Rotating Machinery,” Proceedings of the 9th Annual International Modal Analysis Conference, Part 2, April 15–18, 1991, Florence, Italy, pp. 1270–1275.

Potter

, “A New Order Tracking Method for Rotating Machinery,” Sound and Vibration, September, 1990, pp. 30–35.

Hernandez

Paul

Vosburgh

, “On-Line Measurement and Tracking of Turbine Torsional Vibration Resonances using a New Encoder Based Rotational Vibration Method (RVM),” SAE Technical Paper 961306, Presented at the Aerospace Atlantic Conference, Dayton, OH, May 22–23, 1996.

Maynard

K. P.

Trethewey

, “Blade and Shaft Crack Detection Using Torsional Vibration Measurements, Part 1: Feasibility Studies,” Noise and Vibration Worldwide, December 2000, pp. 9–15.