Flexural Fatigue Strength of Steel Fibrous Concrete Beams

Abstract

The paper presents results of an investigation conducted to study the fatigue strength of steel fibre reinforced concrete (SFRC) beams in flexure. An experimental programme was planned in which about two hundred and thirty three flexural fatigue tests were conducted at different stress levels and stress ratios to obtain the fatigue lives of SFRC containing different volume fractions of steel fibres. One hundred and sixty six complimentary static flexural tests were also conducted to obtain the static flexural strength of SFRC beams prior to fatigue testing. The specimens of size 100 × 100 × 500 mm were used for static flexural as well as flexural fatigue tests and incorporated 0.5, 1.0 and 1.5% volume fraction of corrugated steel fibres of size 0.6 × 2.0 × 30 mm. The concept of equivalent fatigue life was then applied to the fatigue life data to incorporate the effects of stress level, stress ratio and survival probability into the fatigue equation. The results indicate that the distribution of equivalent fatigue life of SFRC can approximately be described by the two-parameter Weibull distribution. The material coefficients of the fatigue equation have been determined corresponding to different survival probabilities so that the fatigue equation can be used to predict the flexural fatigue strength of SFRC.

Keywords

equivalent fatigue life fatigue life stress level stress ratio steel fibre reinforced concrete

References

Kukreja

C.B.

(1981). Structural Characteristics of Steel Fibre Reinforced Concrete, Ph.D. Thesis, University of Roorkee.

Feret

(1906). Etude Experimentale du Ciment Arme, Grauthier-Villiers, Chapter 3.

Kesler

C.E.

(1953). “Effect of speed of testing on flexural strength of plain concrete”, HRB Proceedings, Vol. 32.

Weibull

(1961). Fatigue Testing and Analysis of Results, Pergamon Press, Oxford.

ASTM (1963). A Guide for Fatigue Testing and the Statistical Analysis of Fatigue Data, ASTM Special Technical Publication, 91–A.

Gumble

E.J.

(1963). “Parameters in the distribution of fatigue life”, Journal of Engineering Mechanics, ASCE, October.

Vesic

A.S.

and Saxena

S.K.

(1969). Analysis of Structural Behaviour of Road Test Rigid Pavements, Highway Research Record, No. 291.

Aas-Jakobsen

(1970). Fatigue of Concrete Beams and Columns, Bulletin No. 70–1, NTH Institute for Betonkonstruksjoner, Trondheim, September.

Wirsching

P.H.

and Yao

J.T.P.

(1970). “Statistical methods in structural fatigue”, Journal of the Structural Division, Proceedings of the ASCE, Vol. 108, No. ST1, pp. 1201–1219.

10.

Ballinger

C.A.

(1972). Cumulative Fatigue Damage Characteristics of Plain Concrete, Highway Research Record, No. 370.

11.

Batson

Ball

Bailey

Lenders

and Hooks

(1972). “Flexural fatigue dtrength of dteel fiber reinforced concrete beams”, ACI Journal Proceedings, Vol. 69, No. 11, pp. 673–677.

12.

Kennedy

J.B.

and Neville

A.M.

(1986). Basic Statistical Methods for Engineers and Scientists, A Dun-Donnelley Publishers, New York.

13.

Tepfers

and Kutti

(1979). “Fatigue strength of plain, ordinary, and light weight concrete”, ACI Journal Proceedings, Vol. 76, No. 5, pp. 635–652.

14.

Tepfers

(1979). “Tensile fatigue strength of plain concrete”, ACI Journal Proceedings, Vol. 76, No. 8, pp. 919–933.

15.

Hsu

T.T.C.

(1981). “Fatigue of plain concrete”, ACI Material Journal, Vol. 78., No. 8, pp. 292–305.

16.

Wirsching

P.H.

and Yao

J.T.P.

(1982). “Fatigue reliability-introduction”, Journal of the Structural Division, Proceedings of the ASCE, Vol. 108, No. ST1, pp. 3–23.

17.

B.H.

(1986). “Fatigue analysis of plain concrete in flexure”, Journal of Structural Engineering, ASCE, Vol. 112, No. 2, pp. 273–288.

18.

Ramakrishnan

Oberling

and Tatnall

(1987). Flexural Fatigue Strength of Steel Fiber Reinforced Concrete, SP-105-13, ACI Special Publication, pp. 225–245.

19.

Tatro

S.B.

(1987). Performance of Steel Fiber Reinforced Concrete Using Large Aggregates, Transportation Research Record 1110, TRB Washington, pp. 129–137.

20.

Ramakrishnan

G.Y.

and Hosalli

(1989). Flexural Fatigue Strength, Endurance Limit and Impact Strength of Fiber Reinforced Concretes, Transportation Research Record 1226, TRB, Washington, pp. 17–24.

21.

Johnston

C.D.

and Zemp

R.W.

(1991). “Flexural fatigue performance of steel fiber reinforced concrete-influence of fiber content, aspect ratio and type”, ACI Materials Journal, Vol. 88, No. 4, pp. 373–384.

22.

B.H.

(1991). “Fatigue-life distributions of concrete for various stress levels”, ACI Materials Journal, Vol. 88, No. 2, pp. 122–128.

23.

Shi

X.P.

Fwa

T.F.

and Tan

S.A.

(1993). “Flexural fatigue strength of plain concrete”, ACI Materials Journal, Vol. 90, No. 5, pp. 435–440.

24.

Yin

and Hsu

T.T.C.

(1995). “Fatigue behaviour of steel fiber reinforced concrete in uniaxial and biaxial compression”, ACI Materials Journal, Vol. 99, No. 1, pp. 71–81.

25.

Singh

S.P.

and Kaushik

S.K.

(2000). “Flexural fatigue life distributions and failure probability of steel fibrous concrete”, ACI Materials Journal, Vol. 97, No. 6, pp. 658–667.

26.

Singh

S.P.

and Kaushik

S.K.

(2001). “Flexural fatigue analysis of steel fibre reinforced concrete”, ACI Materials Journal, Vol. 98, No. 4, pp. 306–312.

27.

Singh

S.P.

Mohammadi

and Kaushik

S.K.

(2005). “Flexural fatigue analysis of steel fibrous concrete containing mixed fibres”, ACI Materials Journal, Vol. 102, No. 6, pp. 438–444.

28.

Singh

S.P.

and Kaushik

S.K.

(2003). “Fatigue strength of steel fibre reinforced concrete in flexure”, Cement and Concrete Composites, Vol. 25, pp. 779–786.