Continuous Intrusion Miniature Cone Penetration Test System for Transportation Applications

Abstract

The electronic cone penetrometer is an important investigation tool of choice for in situ site characterization. Application of this proven concept of the cone penetration test (CPT) to transportation applications is described. A miniature cone penetrometer with a projected cone area of 2 cm² has been developed and implemented in a continuous intrusion miniature CPT system (CIMCPT). This device may be used for rapid, accurate, and economical characterization of sites as well as to determine engineering soil parameters needed in the design of pavements, embankments, and earth structures. The miniature CPT (MCPT) gives finer details than the standard 10-cm² cross-sectional area reference cone penetrometer, which makes it attractive for subgrade characterization, quality control assessment, compaction control of embankments, and assessment of ground improvement effectiveness for transportation infrastructure. In situ calibration of the CIMCPT system was conducted at a highway embankment site in Baton Rouge, Louisiana. MCPT penetration profiles were compared with those obtained with the standard cone penetrometer at the same site. The tip resistance of the MCPT was 10 percent higher than that of the reference CPT. The sleeve friction and friction ratio of the reference CPT were higher than that of the MCPT by 12 and 23 percent, respectively. Calibration was also performed to determine empirical cone factors required for estimating undrained shear strength from MCPT data.

Get full access to this article

View all access options for this article.

References

Tumay

M. T.

Implementation of Louisiana Electric Cone Penetrometer System (LECOPS) for Design of Transportation Facilities. Executive Summary, FHWA/LA Report No. LA-94/280 A&B, 1994.

Tumay

M. T.

, and Kurup

P. U.

. Calibration and Implementation of Miniature Electric Cone Penetrometers for Road and Highway Design and Construction Control. LTRC State Project No. 736-13-0036, 1997.

de Lima

D. C.

Development, Fabrication and Verification of the LSU In Situ Testing Calibration Chamber. Ph.D. dissertation. Louisiana State University, Baton Rouge, 1990.

de Lima

D. C.

, and Tumay

M. T.

. Scale Effects in Cone Penetration Tests. Proc., Geotechnical Engineering Congress, Boulder, Colo., GT Div/ASCE, Special Publication No. 27, 1991, pp. 38–51.

Tumay

M. T.

, and de Lima

D. C.

. Calibration and Implementation of Miniature Electric Cone Penetrometer and Development, Fabrication and Verification of the LSU In-situ Testing Calibration Chamber (LSU/CALCHAS), LTRC/FHWA A Report No. GE-92/08, 1992.

Arman

, and McManis

K. L.

. The Effect of Conventional Soil Sampling Methods on the Engineering Properties of Cohesive Soils in Louisiana. Engineering Research Bulletin 117, Louisiana State University, Baton Rouge, 1977.

Chen

B. S.

, and Mayne

P. W.

. Profiling the Overconsolidation Ratio of Clays byPiezocone Tests. Report No. GIT-CEEGEO-94-1, Georgia Tech Research Corporation, Georgia Institute of Technology, Atlanta, 1994.

Terzaghi

Theoretical Soil Mechanics. John Wiley and Sons, New York, 1943.

Meyerhof

G. G.

The Ultimate Bearing Capacity of Foundations. Geo-technique, Vol. 2, No. 4, 1951.

10.

Meyerhof

G. G.

The Ultimate Bearing Capacity of Wedge-Shaped Foundations. Proc., VICSMFE, Paris, Vol. 2, 1961.

11.

Vesic

A. S.

Expansion of Cavities in Infinite Soil Mass. ASCE Journal of Soil Mechanics, Foundation Division, Vol. 98, No. SM3, 1972, pp. 265–290.

12.

Vesic

A. S.

NCHRP Synthesis of Highway Practice 42: Design of Pile Foundations. TRB, National Research Council, Washington, D.C., 1977, 68 pp.

13.

Baligh

M. M.

The Strain Path Method. ASCE Journal of Geotechnical Engineering Division, Vol. 3, No. 9, 1985, pp. 1108–1136.

14.

Houlsby

, and The

C. I.

. Analysis of the Piezocone in Clay. Proc., ISOPT I, Orlando, Fla., Vol. 2, 1988, pp. 777–783.

15.

Lunne

, Christoffersen

H. P.

, and Tjelta

T. I.

. Engineering Use of Piezocone Data in North Sea Clays. Proc., XI ICSMFE, Vol. 2, 1985, pp. 907–912.