Coarse- Versus Fine-Graded Superpave Mixtures: Comparative Evaluation of Resistance to Rutting

Abstract

Both coarse- and fine-graded hot-mix asphalt mixtures can be designed within the gradation control points recommended in Superpave® mix design. Some states have begun to specify only coarse-graded mixtures (below the restricted zone), whereas other states are specifying only fine-graded mixtures (above the restricted zone). A study was conducted to compare coarse-graded Superpave mixtures with fine-graded Superpave mixtures in terms of resistance to rutting to determine whether restrictions on gradations (either coarse- or fine-graded mixtures) are justified. Fourteen mixtures were tested containing two nominal maximum aggregate sizes (9.5 and 19.0 mm), two coarse aggregates (granite and crushed gravel), and four fine aggregates (sandstone, limestone, granite, and diabase). Resistance to rutting of both coarse- and fine-graded mixtures was evaluated by three test methods: asphalt pavement analyzer, Superpave shear tester, and repeated load confined creep test. Statistical analyses of the test data obtained by the three performance tests indicate no significant difference in rutting resistance of coarse- and fine-graded Super-pave mixtures. It has been recommended that mix designs not be limited to designing mixes on the coarse or fine side of the restricted zone.

Get full access to this article

View all access options for this article.

References

Kandhal

P. S.

, and Cooley

L. A.

Jr. NCHRP Report 464: The Restricted Zone in the Superpave Aggregate Gradation Specification. TRB, National Research Council, Washington, D.C., 2001.

Shami

H. I.

, Lai

J. S.

, D’Angelo

J. A.

, and Harman

T. P.

Development of Temperature-Effect Model for Predicting Rutting of Asphalt Mixtures Using Georgia Loaded Wheel Tester. In Transportation Research Record 1590, TRB, National Research Council, Washington, D.C., 1997. pp. 17–22.

Kandhal

P. S.

, and Mallick

R. B.

. Potential of Asphalt Pavement Analyzer (APA) to Predict Rutting of Hot Mix Asphalt. Proc., 1999 International Conference on Accelerated Pavement Testing, Reno, Nev., Oct. 18–20, 1999.

Hand

A. J.

, and Epps

A. L.

. Impact of Gradation Relative to the Super-pave Restricted Zone on Hot-Mix Asphalt Performance. In Transportation Research Record: Journal of the Transportation Research Board, No. 1767, TRB, National Research Council, Washington, D.C., 2001. pp. 158–166.

Chowdhury

A. T.

, Grau

J. D. C.

, Button

J. W.

, and Little

D. N.

. Effect of Aggregate Gradation on Permanent Deformation of Superpave Hot-Mix Asphalt. Presented at 80th Annual Meeting of the Transportation Research Board, Washington, D.C., 2001.

Anderson

R. M

, and Bahia

H. U.

Evaluation and Selection of Aggregate Gradations for Asphalt Mixtures Using Superpave. In Transportation Research Record 1583, TRB, National Research Council, Washington, D.C., 1997. pp. 91–97.

Van de Ven

, de

, Smit

, Lorio

, and McGennis

Validation of Some Superpave Design Parameters by Wheel Testing with the Scale Model Mobile Load Simulator. Proc., 8th International Conference on Asphalt Pavements, Vol. II. Seattle, Wash., 1997.

El-Basyouny

M. M.

, and Mamlouk

M. S.

. Effect of Aggregate Gradation on Rutting Potential of Superpave Mix. Presented at 78th Annual Meeting of the Transportation Research Board, Washington, D.C., 1999.