Safety Evaluation of Sequential Warning Lights in Tapers at Nighttime Work Zones

Abstract

Safety improvement at nighttime work zones is important because of visibility concerns after dark. The deployment of sequential lights is an innovative method to improve driver recognition of lane closures and work zone tapers. Sequential lights are wireless warning lights that flash in a sequence to delineate clearly the taper at work zones. The effectiveness of sequential lights was investigated with the use of controlled field studies. Traffic parameters were collected at the same field site with and without the deployment of sequential lights. Three surrogate performance measures (the speeds of approaching vehicles, the number of late taper merges, and the locations where vehicles merged into an open lane from a closed lane) were used to determine the impact of sequential lights on safety. The results of this study showed that sequential warning lights had a net positive effect: the warning lights reduced the speeds of approaching vehicles and enhanced driver compliance, and the lights shifted overall merge behavior upstream. Statistically significant decreases of 3.56 km/h (2.21 mph) mean speed and 1.61 km/h (1 mph) 85% speed resulted with sequential lights. The shift in the cumulative speed distributions to the left (i.e., speed decrease) was found to be statistically significant with the Kolmogorov–Smirnov test. With sequential lights, there was a statistically significant increase of 1.47 km/h (0.91 mph) in the speed standard deviation, and the percentage of vehicles that merged earlier increased from 53.49% to 65.36%.

Get full access to this article

View all access options for this article.

References

MoDOT Work-Zone Guidelines. Missouri Department of Transportation, Jefferson City, 2004.

Bushman

, Chan

, and Berthelot

. Characteristics of Work Zone Crashes and Fatalities in Canada. Proc., Canadian Multidisciplinary Road Safety Conference XV, Fredericton, New Brunswick, Canada, June 5–8, 2005.

Garber

N.J.

, and Zhao

. Distribution and Characteristics of Crashes at Different Work Zone Locations in Virginia. In Transportation Research Record: Journal of the Transportation Research Board, No. 1794, Transportation Research Board of the National Academies, Washington, D.C., 2002, pp. 19–25.

Highways Agency. Evaluation of Sequential Flashing Cone Lamps. Trial Team: First Annual Report. Department for Transport, London, 2005.

FHWA. Manual on Uniform Traffic Control Devices for Streets and Highways, 2009 ed. U.S. Department of Transportation, November 2009.

Finley

M.D.

, Ullman

G.L.

, and Dudek

C. L.

Sequential Warning-Light System for Work-Zone Lane Closures. In Transportation Research Record: Journal of the Transportation Research Board, No. 1745, TRB, National Research Council, Washington, D.C., 2001, pp. 39–45.

Highways Agency. Flashing Cones and Escorts—Helping Drivers Safely Through Roadworks. Highways Agency Press Office, Department for Transport, London, 2005.

Milton

J.S.

, and Arnold

J. C.

Introduction to Probability and Statistics: Principles and Applications for Engineering and the Computing Science. McGraw-Hill, Inc., New York, 1995.

Special Report 254: Managing Speed: Review of Current Practice for Setting and Enforcing Speed Limits. TRB, National Research Council, Washington, D.C., 1998.

10.

Crammer

Mathematical Methods of Statistics. Princeton University Press, N.J., 1946.

11.

Conover

W. J.

Practical Nonparametric Statistics, 2nd ed. John Wiley & Sons, New York, 1980.

12.

Sun

, Edara

, Hou

, and Robertson

. Cost-Benefit Analysis of Sequential Warning Lights in Nighttime Work Zone Tapers. Final report. Smart Work Zone Deployment Initiative, Iowa State University Institute of Transportation, Ames, 2011.