New Additive for Use in Hot In-Place Recycling to Improve Performance of Reclaimed Asphalt Pavement Mix

Abstract

With the emphasis on sustainability in recent years, hot in-place pavement recycling has been widely used in pavement maintenance in China. However, the application of this technology on modified asphalt pavement does not proceed smoothly because the aged modified asphalt in reclaimed asphalt pavement (RAP) mix is difficult to rejuvenate. So far, few effective rejuvenating agents have been developed for modified asphalt. Therefore, new agents or new methods are called for in modified asphalt pavement recycling. The purpose of the rejuvenating agent is to promote the properties of RAP mix through the rejuvenation of the aged binder. Styrene–butadiene rubber (SBR) latex, a polymer emulsion used to blend modified asphalt with conventional asphalt, now is considered to be a new additive agent to take the place of a rejuvenator but achieve the same goal. Tests were conducted in the laboratory to measure the effect of SBR latex on RAP mix. SBR latex was found to enhance the low-temperature properties of RAP binder efficiently without causing any observable negative influence on RAP mix compaction if a proper dosage was applied. Meanwhile, SBR latex was able to improve the viscoelastic characteristics and other performance of RAP mix, including the resistance to low-temperature cracking, rutting, and moisture damage. Finally, the field application in hot in-place pavement recycling proved the feasibility and effectiveness of using SBR latex.

Get full access to this article

View all access options for this article.

References

Zhou

, Ni

, and Shi

Characteristics of Freeway Traffic Volume and Axle Load Spectrum in Jiangsu Province. Southeast University, China, 2011. http://assets.conferencespot.org/fileserver/fle/32177/filename/166pg6.pdf.

Zhou

, Ni

, and Leng

Development of an Asphalt Pavement Distress Evaluation Method for Freeways in China. In International Journal of Pavement Research and Technology, Vol. 7, Chinese Society of Pavement Engineering, China, 2014, pp. 159–167.

Ali

, and Sobhan

On the Road to Sustainability: Properties of Hot In-Place Recycled Superpave Mix. In Transportation Research Record: Journal of the Transportation Research Board, No. 2292, Transportation Research Board of the National Academies, Washington, D.C., 2012, pp. 88–93.

Research on Hot In-Place Recycling Technology of SMA Pavement. PhD dissertation. Southeast University, Nanjing China, 2010.

Kim

, Kim

, Doh

, and Amirkhanian

Estimation of RAP's Binder Viscosity Using GPC Without Binder Recovery. Journal of Materials in Civil Engineering, Vol. 18, No. 4, 2006, pp. 561–567.

Yildirim

, Ideker

, and Hazlett

Evaluation of Viscosity Values for Mixing and Compaction Temperatures. Journal of Materials in Civil Engineering, Vol. 18, No. 4, 2006, 545–553.

Khatri

, Bahia

H. U.

, and Hanson

Mixing and Compaction Temperatures for Modified Binder Using the Superpave Gyratory Compactor (with Discussion). Journal of the Association of Asphalt Paving Technologists, Vol. 70, 2001, pp. 368–402.

Isacsson

, and Zeng

Relationships Between Bitumen Chemistry and Low Temperature Behavior of Asphalt. Construction and Building Materials, Vol. 11, No. 2, March 1997, pp. 83–91.

ARA, Inc., ERES Consultants Division. Guide for Mechanistic–Empirical Design of New and Rehabilitated Pavement Structures. Final report, NCHRP Project 1–37A. Transportation Research Board of the National Academies, Washington, D.C., 2004. http://www.trb.org/mepdg/guide.htm.

10.

Bonaquist

NCHRP Report 614: Refining the Simple Performance Tester for Use in Routine Practice. Transportation Research Board of the National Academies, Washington, D.C., 2008.

11.

Standard Test Methods of Bitumen and Bituminous Mixture for Highway Engineering. Research Institute of Highway Ministry of Transport. JTG E20–2011. China Communications Press, Beijing, 2011.

12.

Witczak

NCHRP Report 547: Simple Performance Tests: Summary of Recommended Methods and Database. Transportation Research Board of the National Academies, Washington, D.C., 2005.

13.

Bhasin

, Button

J. W.

, and Chowdhury

Evaluation of Simple Performance Tests on HMA Mixtures from the South Central United States. Research Report FHWA/TX-03/9-558-1. FHWA, U.S. Department of Transportation, March 2004.

14.

Hurley

G. C.

, and Prowell

B. D.

Evaluation of Evotherm for Use in Warm Mix Asphalt. NCAT Report 06–02. National Center for Asphalt Technology, Auburn University, Auburn, Ala., June 2006.

15.

Davidson

J. K.

, Lubbers

, and Takamura

Characterization of Unmodified and SBR Latex-Modified Evotherm Warm Mix Binder. Proc., 52nd Annual Conference of the Canadian Technical Asphalt Association, Niagara Falls, Ontario, Canada, Nov. 18–21, 2007, pp. 297–324.