Waste Management & Research: The Journal for a Sustainable Circular Economy

Municipal biowaste is a major environmental issue. Life-cycle assessment is a valuable tool to assess recycling options, and anaerobic digestion and composting have performed adequately. However, reviews indicate several discrepancies between studies. Thus, we critically review 25 life-cycle assessments of the composting and anaerobic digestion of municipal biowaste. Our objective is to identify decisive factors, methodological gaps and processes that affect environmental performance. We generally identified methodological gaps in expanding systems borders. In energy systems, the replaced energy source did not consider power generation or dynamic regulation. All studies adopted mixed energy sources or marginal approaches. Agroecosystems included the carbon sequestration potential and compensation for the production of synthetic fertilizers only. A limited range of scientifically proven benefits of compost use has been reported. In general, studies provided a limited account of the effects of use on land emissions, but contradictory assumptions emerged, mainly in modelling synthetic fertilizer compensation. Only three studies compensated direct emissions from the use of synthetic fertilizers, and none included indirect emissions. Further studies should include an analysis of the additional benefits of compost use, compensate for the effects of emissions from synthetic fertilizer use on land and mix attributional and consequential approaches in energy system expansion.

Septic systems are typically designed to treat domestic wastewater from households without access to centralized facilities. The installation of a food waste disposer (FWD) may increase the discharge of food waste (FW) into the wastewater; therefore, the installation of a FWD is discouraged in households that have a septic system. This study was conducted to determine how a typical dose of FW from a FWD can affect the performance of a septic system in terms of sewage treatment and solids accumulation. A 20-L control tank was compared with an experiment tank to which FW was added, increasing the amount of total suspended solids (TSS) by 31.3% and total chemical oxygen demands by 46.3% for a period of 110 days. Although the influent water quality changed dramatically, the effluent from the experiment tank had a substantially lower percentage increase in water quality parameters compared with the effluent from the control. It was found that in the experiment tank, 75.8% of FW TSS was degraded, whereas only 36.7% of sewage TSS was degraded, and that 18.8% of FW TSS and 44.9% of sewage TSS accumulated in the experiment tank. The addition of FW increased the scum accumulation, even though the dry matter of the scum layer was much less in quantity than the sludge layer. It also increased the lipid content in the sludge. The increase in the scum layer was mainly due to the increase in protein from the addition of the FW. Overall, compared with sewage TSS, FW TSS tends to be more biodegradable, which indicates that the impact on pumping frequency from adding FW will be insignificant.

Pacific island countries are facing critical challenges in managing the growing amount of increasingly diverse wastes because of changing lifestyles and the concentration of populations in urban areas. Although marine plastic waste is an issue in the Pacific region, there have been almost no studies of the estimation and impacts of ocean plastic waste, and measures to control such waste, in these countries. Here, first we conducted a questionnaire survey about consumption and disposal of plastic products at households in Samoa as one of the examples of Pacific island countries to grasp the flow of plastic materials and awareness or behaviour for plastic waste. Then we quantified ocean plastic waste and discussed the effective and needed countermeasures in Pacific island countries. The total amount of mismanaged plastic waste was estimated to be 327,000 or 156,000 t y⁻¹ (depending on the scenario) in Pacific island countries. The regional Pacific island countries contribution to the global total mismanaged plastic waste was estimated to range from 1.3% to 2.7%. The amount of mismanaged plastic waste per capita in some Pacific island countries, such as Solomon Islands and Micronesia, was also ranked highly globally. The main reasons seem to be that waste collection rates are relatively low in rural areas and rates of plastic waste generation are high. To implement solutions, including improving municipal solid waste collection, reducing plastic waste, improving the collection and recycling of plastics, and the integration of a number of policies is essential.

With the rapid development of the electric vehicle market since 2012, lithium-iron phosphate (LFP) batteries face retirement intensively. Numerous LFP batteries have been generated given their short service life. Thus, recycling spent LFP batteries is crucial. However, published information on the recovery technology of spent LFP batteries is minimal. Traditional separators and separation theories of recovering technologies were unsuitable for guiding the separation process of recovering metals from spent LFP batteries. The separation rate of the current method for recovering spent LFP batteries was rather low. Furthermore, some wastewater was produced. In this study, spent LFP batteries were dismantled into individual parts of aluminium shells, cathode slices, polymer diaphragms and anode slices. The anode pieces were scraped to separate copper foil and anode powder. The cathode pieces were thermally treated to reduce adhesion between the cathode powder and the aluminium foil. The dissociation rate of the cathode slices reached 100% after crushing when the temperature and time reached 300℃ and 120 min, respectively. Eddy current separation was performed to separate nonferrous metals (aluminium) from aluminium and LFP mixture. The optimized operation parameters for the eddy current separation were feeding speed of 1 m/s and magnetic field rotation speed of 4 m/s. The separation rate of the eddy current separation reached 100%. Mass balance of the recovered materials was conducted. Results showed that the recovery rate of spent LFP can reach 92.52%. This study established a green and full material recovery process for spent LFP batteries.

Landfill mining is a prospective tool for the recycling of valuable materials (waste-to-material) and secondary fuel (waste-to-energy) from old, therefore more or less stabilised municipal solid waste landfills. The main target of Horizon 2020 ‘SMARTGROUND’ R&D was improving the availability and accessibility of data and information from both urban landfills and mining dumps through a set of activities to integrate all the data – from existing sources and new information retrieved with time progress – in a single EU database. Concerning urban landfills, a new sampling protocol was designed on the basis of the current Hungarian national municipal solid waste analysis standards, optimised for landfill mining. This protocol was then applied in a sampling campaign on a municipal solid waste landfill in Debrecen, Hungary. The composition and parameters of the landfilled materials were measured as a 12-year timescale. The total wet and dry mass of the valuable components possible for utilisation was estimated.

The biodegradable portion of solid waste generated in farmhouses can be treated for energy recovery with small portable biogas plants. This action can be done across the Netherlands and all around the planet. This study aims to appraise the performance of anaerobic digestion of different wastes (cow manure, food waste and garden waste) obtained from a regional farmhouse. Batch reactors were established under mesophilic conditions in order to investigate the impact of ternary mixtures on the anaerobic digestion process performance. Different mixing ratios were set in the batch tests. The upshots from the experiments connoted that ternary digestion with cow manure:food waste:garden waste mixing ratio of 40:50:10 yielded higher biogas amount. The kinetics’ results showed quite good congruence with the experimental study. The results from the kinetic analysis appeared to be in line with the experimental one.

The objectives of this research were to identify the quantities and global warming, acidification and eutrophication potentials associated with household food waste in Bosnia and Herzegovina. In parallel, this study investigated perceptions related to food waste and using the quality function deployment for environment model, correlated reasons for discarding food waste and beliefs associated with food waste. Based on this study, it is estimated that around 2.8 kg of food waste is disposed of by the average household every week. Global warming, acidification and eutrophication potentials associated with household food waste are, on average, 3.49 kg CO₂e/week, 2.42 g SO₂e/week and 8.70 g PO₄e/week, respectively. Also, Bosnian households discard over 80 different pieces of food packaging waste weekly, where plastic packaging is the most dominant packing type. The highest ranked reason for discarding food is linked to plate leftovers. In general, Bosnian citizens feel guilty when they waste food.

In this study, we examine the economic and environmental significance associated with the implementation of an EU waste-separated collection scheme in a developing context – Lebanon. Two scenarios, S1 and S2, representing different intensities of source segregation were analysed. In S1, the average source segregation intensity reached 25% and 13% for the Italian test area and Lebanese test area, respectively. In S2, source segregation intensity increased to 48% and 68% for the Italian and Lebanese test areas, respectively. Passing from S1 to S2 increased collection costs significantly, up to 44% with greater increases in the Italian test area where labour cost is higher. In both areas, environmental impacts decreased with greater source segregation intensity. Savings in the climate change impact and stratospheric ozone depletion potential were lower under the Lebanese test area in comparison with the Italian test area. In contrast, savings in freshwater eutrophication and acidification impact were lower for the Italian test area. The increase in the source segregation intensity resulted in maximum savings for the depletion of abiotic resources, 74% to 77% and 79% to 80% in a developing and developed context, respectively.

This study presents the results of a seasonal municipal solid waste composition campaign, that took place over the period of September 2017 to June 2018 in the capital city of Kazakhstan, Astana. Four sampling campaigns were conducted in order to identify the seasonal variation of municipal solid waste composition, recyclables and energy potential materials, such as combustible fraction, useful for the evaluation of waste-to-energy potential. The combustible fraction was analysed for thermal fuel properties, such as proximate and elemental analyses and gross calorific value. The results over the four different seasons showed that the average recyclable fraction of municipal solid waste on a wet basis of 33.3 wt.% and combustibles fraction was 8.3 wt.%. The largest fraction was the organics (47.2 wt.%), followed by plastic (15.4 wt.%) and paper (12.5 wt.%). Small seasonal variations were observed for organics, paper, plastic and glass fractions. The highest values were found in summer for the organic waste, in spring for paper and plastic and autumn for glass. The recyclables fraction showed an absolute seasonal variation of 5.7% with a peak in the winter season (35.4%) and the combustibles fraction showed a seasonal variation between 8.3 wt.% to 9.4 wt.%. Finally, the average calorific value of the combustible fraction was estimated to be 21.6 MJ kg^-1 on a dry basis.

Greenhouse gas emissions resulting from municipal solid waste management activities and the associated climate change impacts are getting great attention worldwide. This study investigates greenhouse gas emissions and their distribution during waste collection and transport activities in the Dammam region of Saudi Arabia. Greenhouse gas emissions and associated global warming factors were estimated based on diesel fuel consumption during waste collection and transport activities. Then, waste collection and transport data were used to parameterise a mechanistic collection model that can be used to estimate and predict future fuel consumption and greenhouse gas emissions. For the collection and transport of municipal waste in the study area, the average associated total greenhouse gas emissions were about 24,935 tCO₂-eq. Global warming factors for three provinces were estimated as 25.23 kg CO₂-eq t^-1, 25.04 kg CO₂-eq t^-1, and 37.15 kg CO₂-eq t^-1, respectively. Lastly, the American Meteorological Society/Environmental Protection Agency Regulatory Model (AERMOD) modelling system was used to estimate the atmospheric dispersion of greenhouse gas emissions. Model results revealed that the maximum daily greenhouse gas concentrations ranged between 0.174 and 97.3 mg m^-3, while annual average greenhouse gas concentrations were found to be between 0.012 and 27.7 mg m^-3 within the study domain. The highest greenhouse gas concentrations were observed for the regions involving the municipal solid waste collection routes owing to their higher source emission rates.