An experimental method to measure gear tooth stiffness throughout and beyond the path of contact

Abstract

A method is presented that allows the accurate measurement of the tooth pair stiffness of a pair of spur gears. The method reveals the stiffness behaviour throughout the full length of the normal path of contact and also into the extended contact region when tooth corner contact occurs. The method makes use of the properties of transmission error plots for mean and alternating components over a range of tooth loads (Harris maps). It avoids the usual problem when measuring tooth deflections that deflections of other test rig components are difficult to eliminate. Also included are predicted Harris maps for a pair of high contact ratio spur gears, showing the effects of various simplifying assumptions, together with a measured map.

Keywords

gear tooth stiffness gear tooth relief gear transmission error gear path of contact

Get full access to this article

View all access options for this article.

References

Walker

Gear tooth deflection and profile modification. The Engineer, 1938, 166, 410 and 435.

Walker

Gear tooth deflection and profile modification. The Engineer, 1940, 170, 102.

Harris

S. L.

Dynamic loads on the teeth of spur gears. Proc. Instn Mech. Engrs, 1958, 172, 87–112.

Smith

J. D.

Gear Noise and Vibration, 1999 (Marcel Dekker, New York).

Gregory

R. W.

Harris

S. L.

Munro

R. G.

Dynamic behaviour of spur gears. Proc. Instn Mech. Engrs, 1963, 178, 207–226.

Niemann

Winter

Maschinen-elemente, 1985, Vol. 2 (Springer-Verlag, Berlin).

Munro

R. G.

Profile and lead corrections. British Gear Association Design Guide R&D/010, 1989.

Munro

R. G.

Yildirim

Hall

D. M.

Optimum profile relief and transmission error in spur gears. In IMechE First International Conference on Gearbox Noise and Vibration, 1990, pp. 35–41 (Mechanical Engineering Publications, London).

Munro

R. G.

Yildirim

Some measurements of static and dynamic transmission errors of spur gears. In Proceedings of the International Gearing Conference, University of Newcastle upon Tyne, September 1994, pp. 371–376.

10.

Yildirim

Theoretical and experimental research in high contact ratio spur gearing. PhD thesis, University of Huddersfield, 1994.

11.

Palmer

Munro

R. G.

Measurements of transmission error, vibration and noise in spur gears. In British Gear Association Technical Congress, November 1995.

12.

Weber

Sponsored research (Germany), DSIR London, Report 3, 1949.

13.

Steward

J. H.

The compliance of solid, wide-faced spur gears. Trans. ASME, J. Mech. Des., December 1990, 112, 590–595.

14.

Munro

R. G.

Morrish

Palmer

Gear transmission error outside the normal path of contact due to corner and top contact. Proc. Instn Mech. Engrs, Part C, Journal of Mechanical Engineering Science, 1999, 213(C4), 389–400.

15.

Seager

D. L.

Some elastic effects in helical gear teeth. PhD thesis, University of Cambridge, 1967.

16.

Smith

J. D.

Helical gear vibration excitation with misalignment. Proc. Instn Mech. Engrs, Part C, Journal of Mechanical Engineering Science, 1994, 208(C2), 71–79.

17.

Palmer

The effects of profile relief on narrow face width parallel axis gears. PhD thesis, University of Huddersfield, 1999.