Automotive Adsorption Air Conditioner Powered by Exhaust Heat. Part 1: Conceptual and Embodiment Design

Abstract

The significant power used by the mechanical compressor of an automobile (12-17 per cent during commuting for subcompact to mid-size cars) can be eliminated by powering the air conditioner with otherwise wasted exhaust heat. In the present work the conceptual and embodiment design of an exhaust-powered adsorption (desiccant-vapour) air conditioner are traced. The design is preceded by detailed discussion of automotive cooling requirements and the typical driving scenario on which the design is based. Adsorption cooling is then compared with other thermally powered cooling technologies [Stirling, absorption (liquid-vapour), and thermoelectric (i.e. Peltier)], demonstrating that adsorption is the best alternative in terms of size and mass. Next are described inventions to boost specific cooling power (SCP) in kW cooling per kg of air conditioner beyond the state of the art described in the literature while maintaining an adequately high coefficient of performance for cooling (COP_c). The adsorbent is heated and cooled by light oil which in turn is heated and cooled by exhaust and fresh air. Such indirect heating and cooling achieves the required COP_c, permits optimum placement of components in the vehicle, and allows the use of phase-change material (e.g. wax) to store exhaust heat, shortening the time needed to recharge the refrigerant reservoir which provides immediate cooling after start-up of a cold engine.

Keywords

adsorption heat pump automotive air conditioning waste heat recovery

Get full access to this article

View all access options for this article.

References

Boatto

Boccaletti

Cerri

Malvicino

Internal combustion engine waste heat potential for an automotive absorption system of air conditioning. Part 1: Tests on the exhaust system of a spark-ignition engine. Proc. IMechE, Part D: J. Automobile Engineering, 2000, 214, 979–982.

Boatto

Boccaletti

Cerri

Malvicino

Internal combustion engine waste heat potential for an automotive absorption system of air conditioning. Part 2: The automotive absorption system. Proc. IMechE, Part D: J. Automobile Engineering, 2000, 214, 983–989.

Tchernev

D. I.

Emerson

D. T.

High-efficiency regenerative zeolite heat pump. ASHRAE Transactions, 1998, paper OT-88–19-3, pp. 2024–2029.

Tchernev

D. I.

Clinch

J. M.

Closed cycle zeolite regenerative heat pump. In Proceedings of ASME 11th Annual Solar Energy Conference, San Diego, California, 1989, pp. 347–351 (American Society of Mechanical Engineers, New York).

Miles

D. J.

Sanborn

D. M.

Nowakowski

G. A.

Shelton

S. V.

Gas-fired sorption heat pump development. Heat Recovery Syst. and Combined Heat and Power, 1993, 13 (4), 347–351.

Jones

J. A.

Carbon/ammonia regenerative adsorption heat pump. In Proceedings of ASME International Absorption Heat Pump Conference on

Advanced Energy Systems (AES), 1993, vol. 31, pp. 449–455.

10.

11.

12.

13.

14.

Miller

E. B.

The development of silica gel refrigeration. Am. Soc. Refrig. Engrs, April 1929, 17 (4), 103–108.

15.

Shelton

S. V.

Wepfer

W. J.

Miles

D. J.

Ramp wave analysis of the solid/vapor heat pump. Trans. ASME, J. Energy Resources Technol. Adv. Energy Syst. (AES) Div., March 1990, 112 (1), 70–75.

16.

Saha

Akisawa

Kashiwagi

Thermo-dynamic analysis of adsorption refrigeration cycles. In Proceedings of 1997 32nd Intersociety Energy Conversion Engineering Conference, vol. 2, Electrochemical Technologies, Conversion Technologies, and Thermal Management, Honolulu, Hawaii, 1997, p. 1258 (American Society of Mechanical Engineers, New York).

17.

Cerkvenik

Poredos

Ziegler

Influence of adsorption cycle limitations on the system performance. Int. J. Refrig., 2001, 24 (6), 475–485.

18.

Restuccia

Cacciola

Performances of adsorption systems for ambient heating and air conditioning. Int. J. Refrig., 1999, 22 (1), 18–26.

19.

Cacciola

Restuccia

van Benthem

G. H. W.

Influence of the adsorber heat exchanger design on the performance of the heat pump system. Appl. Thermal Engng 1999, 19 (3), 255–269.

20.

Zhang

L. Z.

Wang

Effects of coupled heat and mass transfers in adsorbent on the performance of a waste heat adsorption cooling unit. Appl. Thermal Engng, 1999, 19 (2), 195–215.

21.

Poyelle

Guilleminot

Meunier

Experimental tests and predictive model of an adsorptive air conditioning unit. Ind. Engr, Chem. Resour., Am. Chem. Soc., 1999, 38 (1), 298–309.

22.

Meunier

Poyelle

LeVan

M. D.

Second law analysis of adsorptive refrigeration cycles: The role of thermal coupling entropy production. Appl. Thermal Engng, 1997, 17 (1), 43–55.

23.

Lambert

M. A.

Jones

B. J.

Review of regenerative adsorption heat pumps. Am. Inst. Aeronaut. Astronaut. J. Thermophys. and Heat Transfer, October-December 2005, 19 (4), 471–485.

24.

Lambert

M. A.

Jones

B. J.

Adsorption heat pump. US Pat. Application BSDSU 1036289, filed 10 June 2005.

25.

ASME Boiler and Pressure Vessel Code, Section VIII: Rules for Construction of Pressure Vessels, Division 1, American Society of Mechanical Engineers (ASME), New York, 1 July 1986, pp. 382–383.