Heat flux measurement and pressure-based heat release analysis have been performed on a spray-guided direct-injection spark-ignition single-cylinder research engine. A two-dimensional model of the heat flux sensor has been used to calculate the heat flux from the measured surface temperature. The effects of the ignition timing, air-fuel ratio, and mixture preparation on the engine heat flux and heat release have been investigated at a specific operating condition. An engine thermodynamic simulation code has been used to predict the gas-to-wall heat transfer using different heat transfer correlations. It was found that both the heat release rate and the heat flux are strongly influenced by ignition timing and air-fuel ratio. The results also show that late direct injection has a faster initial burn rate even compared with the plenum injection mode. The modelled heat transfer has been compared with the measured results and a modified Woschni correlation has been proposed.
SzekelyG. A.AlkidasA. C.Combustion characteristics of a spray-guided direct injection stratified-charge engine with a high squish piston. SAE paper 2005–01-1937, 2005.
3.
PriceP.StoneC. R.CollierT.DaviesM.Particulate matter and hydrocarbon emissions measurements: Comparing first and second generation DISI with PFI in single cylinder optical engine. SAE paper 2006–01-1263, 2006.
4.
WirthM.ZimmermannD.FriedfeldtR.CaineJ.SchamelA.DaviesM.PeirceG.StorchA.Ries-MüllerK.GansertK.-P.PilgramG.OrtmannR.WürfelG.GerhardtJ.A cost optimised gasoline spray guided direct injection system for improved fuel economy. In Proceedings of the IMechE Seminar onFuel Economy and Engine Downsizing, 2004.
HarigayaY.TodaF.OhyagiS.TsujiH.Surface temperature and wall heat flux in a spark-ignition engine under knocking and non-knocking conditions. SAE paper 891795, 1989.
7.
MyersJ. P.AlkidasA. C.Effects of combustion-chamber surface temperature on the exhaust emissions of a single-cylinder spark-ignition engine. SAE paper 780642, 1978.
8.
RaineR. R.StoneC. R.GouldJ.Modelling of nitric oxide formation in spark ignition engines with a multizone burned gas. Combust. Flame, 1995, 102, 241–255.
9.
GilaberP.PinchonP.Measurements and multidimensional modelling of gas-wall heat transfer in a S.I. engine. SAE paper 880516, 1988.
10.
AlkidasA. C.Heat transfer characteristics of a spark-ignition engine. Trans. ASME, J. Heat Transfer, 1980, 102 (2), 189–193.
11.
AlkidasA. C.PuzinauskasP. V.PetersonR. C.Combustion and heat transfer studies in a spark-ignited multivalve optical engine. SAE paper 900353, 1990.
12.
AlkidasA. C.MyersJ. P.Transient heat-flux measurements in the combustion chamber of a spark-ignition engine. Trans. ASME, J. Heat Transfer, 1982, 104, 62–67.
13.
GatowskiJ. A.SmithM. K.AlkidasA. C.An experimental investigation of surface thermometry and heat flux. Expl Thermal Fluid Sci., 1989, 2, 280–292.
14.
LawtonB.Effect of compression and expansion on instantaneous heat transfer in reciprocating internal combustion engines. Proc. Instn Mech. Engrs, Part A: J. Power and Energy, 1987, 201 (3), 175–186.
15.
ButtsworthD. R.Transient response of an erodable heat flux gauge using finite element analysis. Proc. Instn Mech. Engrs, Part D: J. Automobile Engineering, 2002, 216, 701–706.
AnnandW. J. D.Heat transfer in the cylinders of reciprocating internal combustion engines. Proc. Instn Mech. Engrs, 1963, 177, 973–990.
18.
AnnandW. J.D.MaT. H.Instantaneous heat transfer rates to the cylinder head surface of a small compression-ignition engine. Proc. Instn Mech. Engrs, 1970, 185, 976–988.
19.
OverbyeV. D.BennethumJ. E.UyeharaO. A.MyersP. A.Unsteady heat transfer in engines. SAE Trans., 1961, 69, 461–494, SAE paper 201C.
20.
EichelbergG.Some new investigations on old combustion engine problems. Engineering, 1939, 148, 463–446, 547–560.
21.
HohenbergG. F.Advanced approaches for heat transfer calculations. SAE paper 790825, 1979.
22.
WoschniG.A universally applicable equation for the instantaneous heat transfer coefficient in the internal combustion engine. SAE Trans., 1967, 76, SAE paper 670931.
23.
WangX.StoneC. R.ButtsworthD. R.StevensR.AritaY.Finite element analysis of eroding type surface thermocouple with application to engine heat flux measurement. SAE paper 2006–01-1045, 2006.
24.
StoneC. R.Introduction to internal combustion engines, 1999 (Macmillan, London).
25.
OldFieldM. L. G.Guide to impulse response heat transfer signal processing. OUEL Report 2233/2000, Department of Engineering Science, University of Oxford, 2000.
26.
RassweilerG. M.WithrowL.Motion pictures of engine flame correlated with pressure cards. SAE paper 800131, 1980 (originally presented in 1938).
27.
LawesM.LeeY.MarquezN.Comparison of iso-octane burning rates between single-phase and two-phase combustion for small droplets. Combust. Flame, 2006, 144 (3), 513–525.
28.
ChangJ.GüralpO.FilipiZ.AssanisD.KuoT.NajtP.RaskR.New heat transfer correlation for an HCCI engine derived from measurements of instantaneous surface heat flux. SAE paper 2004–01-2996, 2004.
