ly as good as its accuracy when compared to real-world measurements. In this work, we take two recommendations from a thermoelectric machine learning model, TaVO₅ and GdTaO₄, and measure their thermoelectric properties of Seebeck coefficient, thermal conductivity, and electrical conductivity. We see that the predictions are mixed; thermal conductivities are correctly predicted, while electrical conductivities and Seebeck coefficients are not. Furthermore, we explore TaVO₅’s unusually low thermal conductivity of 1.2 Wm⁻¹K⁻¹, and we discover a possible new avenue of research of a low thermal conductivity oxide family.

27:T428,

Three types of alumina powders and a polymer electrolyte Isobam system were used to fabricate translucent alumina ceramics via gelcasting, and each powder had the highest attainable solid loading. The effects of alumina particle size on slurry dispersion, microstructures and properties of green bodies and ceramics were investigated. All of the high-solid loading slurries contained strong aggregates, which could bridge with each other to form weak agglomerates. The smaller the initial particle size was, the more the contained particle number per aggregate. In addition, the smaller the aggregate size was, the lower the sintering activation energy of the ceramic and, finally, the higher the relative density. The initial particle size of the powder may not be the critical factor determining ceramic sintering, but the aggregate size and effective volume fraction of the aggregates may be the critical factors. Finally, the in-line transmittance of the ceramic with a higher density reached 22% at a wavelength of 650 nm and a thickness of 0.8 mm.

28:T4a8,

Flash sintering (FS) is of great interest today, as it allows the production of high-density ceramics in seconds at lower temperatures than conventional sintering. In this study, the effects of conventional sintering at 1250°C for 4 h and FS at various electric fields (12.5, 25, 50 and 75 V/mm) on copper smelting slag (CSS), which is a multiphase material system, are investigated. The results show that FS occurs at substantially lower temperatures with much shorter times than conventional sintering, in conjunction with improved density and hardness values for CSS. The optimum condition for better densification is observed for the sample applied the 25 V/mm electric field in 554 s, and the maximum power density of about 76.49 mW/mm³. On the other hand, the shortest FS duration is achieved with the sample applied 75 V/mm in 114 s. Flash sintering at lower temperatures also stabilizedthe magnetite-hematite the phase transition, which arouses at higher temperatures. Overall, FS has made a huge contribution to reducing sintering time and temperature while providing better microstructure integrity and mechanical properties in multiphase materials systems.

29:T437,

The accuracy of computer-aided design/computer-aided manufacturing (CAD/CAM) methods plays an important role in the clinical success of ceramic veneers. This study aimed to evaluate the impact of different CAD/CAM methods, including subtractive, hybrid, and additive manufacturing, on the trueness and precision of ceramic veneers. A typodont central incisor was prepared for a laminate veneer, followed by the design of a veneer with CAD software. Ceramic veneers were fabricated with four different CAD/CAM methods, including milled lithium disilicate, pressed lithium disilicate with three-dimensional (3D) printed wax patterns, milled zirconia, and 3D-printed zirconia. All veneers were scanned and imported to 3D inspection software for trueness and precision evaluation. Laminate veneers fabricated with all investigated methods exhibited clinically acceptable trueness and precision. Pressed lithium disilicate veneers from 3D-printed wax patterns and 3D-printed zirconia veneers showed lower precision of the fitting surfaces compared to their milled counterparts.

2a:T58d,